How to deal with the deviation of each station when adjusting the cam divider? As shown in the video below:

The above situation may occur due to deviations in the drilling of the flange surface of the divider, deviations in the drilling of the large disc, or deviations in the hole positions of the fixed robot. In short, the holes are not completely concentric. It is very important to keep all the holes concentric when designing.

If there is a misalignment, you can find a way to remedy it. Drill several holes in the fixed disc and the cam divider flange surface into arc shapes. After finding the corresponding positions, drill a few more positioning holes on the large disc and the cam divider flange surface to fix them, and then tighten them with screws.

Regarding questions about cam dividers, LVNCAM cam dividers from LVN Automation welcomes everyone to communicate and learn together.