The use, maintenance, inspection and repair of the cam divider are the key to ensuring its normal operation and extending its service life.

First of all, always clean up debris and scraps around the transmission system to prevent obstruction of movement.

Secondly, the input and output shaft connectors and transmission parts need to be regularly inspected. Pay special attention to the looseness of the coupling, pulley, sprocket, gear and output transmission body, as well as the tension of the belt and sprocket and the meshing clearance of the gear, etc. These must be ensured to be in normal condition. If the following conditions are found, stop the operation immediately:

1. The cam vibrates abnormally.

2. The cam makes an abnormal sound.

3. The cam has a reverse impact in the stationary area.

4. The cam has no segmented output in the corresponding intermittent times, or the segmented output is unstable at a certain position, or there is no segmented output at all.

If the above situation occurs, you can remove the mechanism, open the back cover of the mechanism, and find out the cause.

- If the cam is damaged and cannot be used any more, please contact us to replace the cam. If the cam is not damaged or is only slightly damaged, it can still be used, but its axial position cannot be adjusted privately.

- If the needle bearing in the split wheel is damaged, you can remove the output split shaft and replace the needle bearing. There are two options:

- One way is to loosen the output sleeve and take out the output shaft, but do not loosen the gland at the rear end. This way, the axial position will not change when you reinstall it.

- Another way is to loosen the locking nut at the rear end of the output shaft and the output sleeve at the front end, take out the output shaft and sleeve together, and then when you put them back, you only need to tighten the nut to return the output shaft to its original position.

The above is the relevant content about the use, maintenance, inspection and repair of the cam divider. Make sure to operate according to the requirements to ensure the normal operation of the divider and extend its service life.